Gas Furnaces

DGAA Series Gas Furnaces by Coleman

  • 80%+ AFUE Manufactured Home Gas Furnaces
  • A/C ( air condition ) ready up to 4 tons of heat pump
  • Built-in A-coil cabinet
  • Full louver high impact plastic return air door
  • Standard replaceable filters included
  • Conversion to propane gas is fast and easy
  • All models are provided with a convertible gas valve and gas orifices for both natural and propane gas
  • 2 Year Parts and Labor Warranty with 10 Year heat exchanger warranty

M3RL Series for Modular Housing High Efficiency / Direct Vent Condensing Downflow Gas Furnace

Induced Draft – 90+ AFUE

Input 60,000 & 80,000 Btuh

The high efficiency downfl ow gas furnace is especially designed for Modular Housing. It may be installed in a utility room, or enclosed in a closet. CSA design certified for use in the United States and Canada.

  • Compact and easy to install with just a 33 inch high cabinet.
  • 100% Fired and Tested.
  • Clean and quiet operation.
  • Fixed 30-second blower delay at furnace start up.
  • Fixed 30-second post purge increases life of heat exchange.r
  • Dependable hot surface igniter with a 20 year history of reliability assures no call-backs because of handling.
  • Tubular primary heat exchanger – Heavy aluminumized Steel assures a long life.
  • 90 Second fixed cooling cycle blower-off delay (TDR)Increases cooling performance
  • Sealed combustion approved for direct vent furnace, Category IV venting system – May be vertically or horizontally vented using a two-pipe system for maximum flexibility in installation.
  • Multi-Speed direct drive blower for a wide range of cooling capacities.
  • LP Convertible – Simple burner orifice and gas valve Regulator change for ease of convertibility.
  • 3 Amp fuse protection against high and low voltage shorts.
  • Stainless steel secondary heat exchanger assures a long life.
  • Fixed cooling cycle blower-off delay (TDR) increases cooling performance when matched with a NORDYNE coil.
  • Sealed combustion approved for direct vent furnace, category IV venting system – May be vertically or horizontally vented using a two-pipe system for maximum flexibility in installation.
  • Multi-speed direct drive blower — Designed to give a wide range of cooling capacities. 40VA transformer included.
  • LP convertible — Simple burner orifi ce and gas valve regulator change for ease of convertibility.
  • Diagnostic light fl ashes identify limit failure, pressure switch failure and improper ground and polarization — for easy troubleshooting.
  • 3 amp fuse protection against low voltage shorts; protects transformer and control board.
  • Low voltage terminal board for easy fi eld wiring.
  • Easy open pawl latch secures the door fi rmly for transit, yet allows easy removal for access.
  • Appliance quality door protects against rust and other corrosion. Baked enamel fi nish allows for easy cleaning.
  • Fully insulated cabinet insures minimized heat loss and quiet operation.

Note: The M3RL will fit in the same footprint and uses the same duct connector as the M1 furnaces. The design of the M3RL allows for direct substitution in place of the M1 series furnaces.

MG9S 95% Gas Furnaces for Manufactured Housing

  • Zero clearance allows these furnaces to be installed in tight areas
  • Compact and easy to install with just a 33 inch high cabinet
  • All models are provided with a convertible gas valve and orifices for both natural and propane gas
  • 100% shut off main gas valve for extra safety
  • Hi-tech tubular aluminized heat exchanger for extended life
  • Extremely quiet inducer operation
  • Energy Star® compliant makes this unit eligible for current federal rebates
  • Built-in high level self diagnostics with fault codes displays standard on integrated control module insures reliable operation